Is your pump giving you problems? Haven’t got a clue what to do with that thing? Sometimes, you might have difficulty managing the items in your house, like the cistern pump.

You may look out on the internet for some tips on handling the issue. But, finding one relevant to your case on the internet might be a little tricky. You might want some step-by-step illustrations on how to go about it.

This is where this article comes in. Here’s our guide to installing a cistern pump the right way.

Supplies Needed for Installation

Cistern pump installation is not difficult, but there are a few supplies you will need to do it correctly. You will need a cistern. This can be above ground or below ground and is typically made of concrete, metal, or plastic.

The size of the cistern will determine the size of the pump you need. Then, you will need to purchase or find cistern pumps here that are the proper size and has the correct power output for your cistern.

You will also need a discharge pipe and fittings, which will be used to connect the pump to the cistern. Finally, you will need cable and wire to connect the pump to a power source. 

Dig a Hole for the Cistern

You will need to dig a hole for the pump to sit in. This pump will help to move water from the cistern to your home.

Make sure that the hole is large enough to accommodate the pump, and that it is deep enough to allow the pump to sit below the level of the cistern.

After the hole is dug, you can start the installation of the pump and begin using it to move water to your home.

Put in the Pump

To do this, start by determining the location of the pump. The location should be close to the outlet of the cistern so that the water can be easily pumped out.

Drill a hole in the cistern and insert the pump. And then, connect the pump to a power source and test it to ensure it is working properly. And since you are working with water and electricity, always ensure workplace safety.

Connect Pipes to the Pump

Locate the inlet and outlet ports on the pump. You’ll need to measure the distance between the ports and cut two lengths of pipe that will reach from the pump to the desired location of the outlet and inlet ports.

Once the pipes are cut to size, clean the ends of the pipes and the ports on the pump with a clean rag. Apply a generous amount of pipe sealant to the ends of the pipes and the ports on the pump.

Insert the pipes into the ports on the pump and tighten the pipe clamps to secure the pipes in place. And then, turn on the pump and check for leaks.

Installing Cistern Pump The Right Way

In conclusion, follow these cistern pump guides during installation for the best results. Make sure to level the cistern pump so that it sits firmly on the ground.

Be careful not to overtighten the fittings, and always connect the discharge pipe to the pump before connecting the power. Once everything is connected, turn on the power and check for leaks.

Did you find this article helpful? Just visit our website for more awesome content like this.